Digital thermostat with one-way LED display withtemperature probe.
Ideal for use with heating accessories.
Output power: 1500 W
Long sensor cable: 1m
With delayed start function
Specifications:
Temperature control range: -50℃~110℃
Temperature measurement error: ±0.2℃
Temperature control error : ±0.1℃
Sensor model: NTC10K
Sensor Long: 100CM
Output Power: 1500W
Output Current: Max 10A
Size: 120*59*30mm
Working Type: Direct output (Output Voltage =Input Voltage)
Power Supply Plug : EU Plug
How to restore the factory seting
1- When connect to power supply, press the Up and Down buttons at the same time moew than 3s,display show 888
2- If display show LLL,means the sensor fault, need check this sensor
3- The display show HHH , mean Test Temperature more than measurement range
P0: set start temperature:
Press the setting buttom, enter the internal menu,the default display,for the P0, and then click the settings button, use and and down buttons to set the starting temperature
P1 : Set stop temperature:
Press the setting buttom, enter the internal menu,the default display,for the P0, use and and down buttons change to P1,and then click the settings button, use and and down buttons to set the starting temperature
P2:set temperature calibration
Press the setting buttom, enter the internal menu,the default display,for the P0, use and and down buttons change to P2,and then click the settings button, use and and down buttons to set temperature calibration
when you setting, if detection of temperature is grater than the actual temperature of 0.5C, then need setting the calibration temperature is 0.5C
when you setting, if detection of temperature is smaller than the actual temperature of 1C, then need setting the calibration temperature is 1C
P3 : set delay start
Press the setting buttom, enter the internal menu,use and and down buttons change to P3,press set button again,use and and down buttons to set delay time(minutes)